Fault Adaptive Control of Overactuated Systems Using Prognostic Estimation

##plugins.themes.bootstrap3.article.main##

##plugins.themes.bootstrap3.article.sidebar##

Published Oct 10, 2010
Brian M. Bole Douglas W. Brown Hai-Long Pei Kai Goebel Liang Tang George Vachtsevanos

Abstract

Most fault adaptive control research addresses the preservation of system stability or functionality in the presence of a specific failure (fault). This paper ex- amines the fault adaptive control problem for a generic class of incipient failure modes, which do not initially affect system stability, but will eventually cause a catas- trophic failure to occur. This risk of catastrophic failure due a component fault mode is some monotonically in- creasing function of the load on the component. Assum- ing that a probabilistic prognostic model is available to evaluate the risk of incipient fault modes growing into catastrophic failure conditions, then fundamentally the fault adaptive control problem is to adjust component loads to minimize risk of failure, while not overly de- grading nominal performance. A methodology is pro- posed for posing this problem as a finite horizon con- strained optimization, where constraints correspond to maximum risk of failure and maximum deviation from nominal performance. Development of the methodol- ogy to handle a general class of overactuated systems is given. Also, the fault adaptive control methodology is demonstrated on an application example of practical significance, an electro-mechanical actuator (EMA) con- sisting of three DC motors geared to the same output shaft. Similar actuator systems are commonly used in aerospace, transportation, and industrial processes to ac- tuate critical loads, such as aircraft control surfaces. The fault mode simulated in the system is a temperature de- pendent motor winding insulation degradation.

How to Cite

M. Bole, B. ., W. Brown, D. ., Pei, H.-L. ., Goebel, K. ., Tang, L. ., & Vachtsevanos, G. (2010). Fault Adaptive Control of Overactuated Systems Using Prognostic Estimation. Annual Conference of the PHM Society, 2(1). https://doi.org/10.36001/phmconf.2010.v2i1.1870
Abstract 328 | PDF Downloads 75

##plugins.themes.bootstrap3.article.details##

Keywords

fault adaptive controls, optimization, diagnostics and prognostics, incipient fault, overactuated, load distribution

References
Arulampalam, M. S., Maskell, S., Gordon, N., & Clapp, T. (2002, Feb). A Tutorial on Particle Filters for Online Nonlinear/Non-Gaussian Bayesian Tracking. IEEE Transactions on Signal Processing, 50(2), 174-188.

Bole, B. M., Brown, D., & Vachtsevanos, G. (2010). Automated Contengency Management (ACM) for Overactuated Systems.

Brown, D., Edwards, D., Georgoulas, G., Zhang, B., & Vachtsevanos, G. (2008). Real-Time Fault Detection and Accommodation for COTS Resolver Position Sensors. In 1st International Conference on Prognostics and Health Management (PHM).

Brown, D., Georgoulas, G., Bae, H., Chen, R., Y. Ho, G. T., Schroeder, J. B., et al. (2009). Particle filter based anomaly detection for aircraft actuator systems. In IEEE Aerospace Conference.

Brown, D., Georgoulas, G., Bole, B., Pei, H.-L., Orchard, M., Tang, L., et al. (2009, october). "Prognostics Enhanced Reconfigurable Control of Electro-Mechanical Actuators". In 2nd International Conference on Prognostics and Health Management (PHM).

Drozeski, G. R. (2005). A Fault-Tolerant Control Architecture for Unmanned Aerial Vehicles. Unpublished doctoral dissertation, Georgia Institute of Technology.

Harkegard, O., & Glad, S. T. (2005, January). Resolving Actuator Redundancy - Optimal Control vs. Control Allocation. Automatica, 41(1), 137-144.

Li, Y., Kurfess, T., & LIANG, S. (2000, September). Stochastic Prognostics for Rolling Element Bearings. Mechanical Systems and Signal Processing, 14(5), 747-762.

Monaco, J. F., Ward, D. G., & Bateman, A. J. (2004, September). A Retrofit Architecture for Model- Based Adaptive Flight Control. In AIAA 1st Intelligent Systems Technical Conference.

Montsinger, V. M. (1930). Loading transformers by temperature. Transactions of the American Institute of Electrical Engineers, 32.

M.Zhang, Y., & J.Jiang. (2002). Active fault-tolerant control system against partial actuatorfailures. IEE proceedings on control theory and applications, 149(149), 95.

Nestler, H., & Sattler, P. K. (1993, January). On-line estimation of temperatures in electrical machines by an observer. Electric Power Components and Systems,, 21(1), 39-50.

Oppenheimer, M. W., Doman, D. B., & Bolender, M. A. (2006). Control allocation for over-actuated systems. In 14th Mediterranean Conference on Control and Automation.

Orchard, M. (2007). A particle filtering-based framework for on-line fault diagnosis and failure prognosis. Unpublished doctoral dissertation, Georgia Institute of Technology.

Zhang, B., Georgoulas, G., Orchard, M., Saxena, A., Brown, D., Vachtsevanos, G., et al. (2008). Rolling Element Bearing Feature Extraction and Anomaly Detection Based on Vibration Monitoring. In 16th Mediterranean Conference on Control and Automation.

Zhank, Y. M., & Jiang, J. (2002, January). Active fault-tolerant control system against partial actuator failures. IEE Proc.-Control Theory Appl., 149(1).
Section
Technical Research Papers

Most read articles by the same author(s)

<< < 1 2 3 4 5 > >>